Maintenance Checklists

1. Blower Motor – measure amperage and voltage for proper operation
2. Thermostat – test for proper operation, calibrate and level
3. Clean existing air filter (as needed)
4. Bearing – inspect for wear and lubricate
5. Clean indoor coil if accessible
6. Condensate Drain – flush and treat with anti-algae
7. Inspect Condenser Coil
8. Refrigerant – monitor operating pressures
9. Safety Devices – inspect for proper operation
10. Electrical Disconnect Box – inspect for proper rating and safe installation
11. Electrical Wiring – inspect and tighten connections
12. Test/inspect contactors for burned, pitted contacts
13. Inspect electrical for exposed wiring
14. Inspect and test capacitors
15. Inspect fan blade
16. Clean condenser coil and remove debris
17. Inspect service valves for proper operation
18. Measure Supply/Return temperature differential
19. Inspect duct work for energy loss
20. Compressor – monitor, measure amperage and volt draw and wiring connections

Furnace Tune-Up, Cleaning and Safety Inspection
Keep Your Furnace at Peak Efficiency with an Annual Tune-Up – and Safeguard your Family with a FREE Carbon Monoxide Test.  Tune-up your furnace and Service Champions guarantees you a 100% profit in energy savings plus receive a free carbon monoxide test. 

Service Champions' trained technicians will perform a 60-90-minute precision tune-up and professional cleaning including the following 20 operations:

1. Carbon Monoxide - test air flow duct system for dangerous carbon monoxide
2. Thermostat – test for proper operation, calibrate and level
3. Inspect for combustible material around furnace
4. Ignition System – test for safe and proper operation
5. Exhaust System – test for proper venting
6. Measure Supply/Return temperature differential
7. Safety & Control Circuits – test for proper operation
8. Inspect and adjust fan belt tension (if applicable)
9. Clean existing air filter
10. Lubricate and clean blower motor air vents
11. Furnace Burner – clean and inspect (brush and vacuum)
12. Heat Exchangers – clean and inspect (brush and vacuum)
13. Clean furnace exterior
14. HydroScan™ certification of heat exchangers for dangerous cracks and wear
15. Gas Pressure – measure and adjust for peak efficiency
16. Lubricate all moving parts per manufacture
17. Blower Motor – measure amperage and voltage for proper operation
18. Electrical Wiring – inspect and tighten connections
19. Combustion Vents – clean and inspect (upper and lower)
20. Natural Gas – check for leaks