With Northern California’s cold weather in full swing, you rely on your furnace more than ever. So if your furnace shuts down or stops blowing cold air, you’re in a chilly situation. However, fixing the problem can be easier than you think.
These 5 fixes can solve most furnace problems without you needing to pay for a repairman to come out.
1) Change the furnace’s air filter if it’s dirty
If the furnace filter gets too dirty, it will block the return air flow to the furnace. It’s like putting a blanket on your head and asking you to breathe normally.
A dirty filter causes these problems:
A dirty filter will also cause soot to build up in the heat exchanger, causing your furnace to run inefficiently and reduce it’s life span. Check the air filter every one to three months and change it if it’s dirty.
REMEMBER: Turn off your furnace’s shut off switch (found on the furnace) and set the thermostat to off before changing the air filter.
2) Check your thermostat
There may be nothing wrong your furnace at all. Your thermostat, the control centre of your heating system, may be the culprit.
If your furnace isn’t coming on or isn’t blowing hot air try these simple troubleshooting tips with your thermostat before you call a repairman:
3) Make sure the blower motor panel is shut
If someone opened the blower’s panel to do a repair, they may not have shut the panel properly If it’s not pressed in all the way, a safety device will prevent the furnace from running. So make sure you securely shut furnace blower panel.
4) Inspect your air ducts
Let’s say your furnace seems to be working fine. Blower is running, hot air is coming out…in most rooms. You’ve got a few cold spots in your home. Why? The answer is in your air ducts.
First, check for handles protruding from the ducts. These are dampers that control the airflow. Make sure they’re fully open (i.e., the handle is parallel with the ductwork).
If some of your rooms are still cold, your ducts may have gaps, cracks or holes in them allowing the hot air to escape. This is what we call leaking ducts. These leaks not only make the room cold, but it
Find where the leaks are in the ducts and seal them with a mastic sealant.
5) Make sure the gas valve is open
Like with the blower panel, someone may have shut the gas valve to do a repair and forgot to turn it back on on. If it’s off, no gas will enter the furnace, so nothing will burn. Simply turn it back on (the handle should be parallel with the gas pipe) ,and you’re good to go.
When in doubt, call a professional
Obviously, these fixes won’t solve all your furnace problems. So, if none of these do the job, it’s best to call a professional for help.
Mon-Thu: 7am - 7pm
Fri-Sun: 7am - 6pm
Send us your feedback on your experience and we will get back to you in 1 to 2 working days.